- Spine Unit, Orthopedic Department Hospital Español, Mendoza, Argentina
- Neurosurgery Department, Hospital de Clínicas “José de San Martín”, Buenos Aires, Argentina
- Neurosurgery Department, Caxias do Sul University, Brazil
Correspondence Address:
A. Guiroy
Neurosurgery Department, Caxias do Sul University, Brazil
DOI:10.4103/sni.sni_344_17
Copyright: © 2018 Surgical Neurology International This is an open access article distributed under the terms of the Creative Commons Attribution-NonCommercial-ShareAlike 3.0 License, which allows others to remix, tweak, and build upon the work non-commercially, as long as the author is credited and the new creations are licensed under the identical terms.How to cite this article: A. Guiroy, A. Sícoli, N. Gonzalez Masanés, A. Morales Ciancio, M. Gagliardi, A. Falavigna. How to perform the Wiltse posterolateral spinal approach: Technical note. 14-Feb-2018;9:38
How to cite this URL: A. Guiroy, A. Sícoli, N. Gonzalez Masanés, A. Morales Ciancio, M. Gagliardi, A. Falavigna. How to perform the Wiltse posterolateral spinal approach: Technical note. 14-Feb-2018;9:38. Available from: http://surgicalneurologyint.com/?post_type=surgicalint_articles&p=8777
Abstract
Background:The paraspinal, posterolateral, or Wiltse approach is an old technique that observes the principles of an MIS procedure. The aim of this study was to provide a step-by-step description from the literature of the Wiltse paraspinal approach and analyze its main advantages and limitations.
Methods:Here, we provide a step-by-step description of the Wiltse approach. Utilizing PubMed and Lilacs and the Mesh terms “Wiltse approach,” “paraspinal approach,” “muscle sparing approach,” and “lumbar spine,” we identified 10 papers. We then put together, based on these publications, a step-by-step analysis of the preparation, patient positioning, skin incision, fascial opening, dissection, bone identification, retractors, deperiostization, decompression, discectomy, instrumentation, arthrodesis, and closure for the Wiltse technique.
Results:Most papers underscored the minimally invasive aspects of the typical Wiltse approach. Advantages included minimal intraoperative bleeding, a shorter hospital length of stay, and a low infection rate.
Conclusion:The classical approach described by Wiltse is essentially minimally invasive, sparing both the muscle planes and soft tissues, allowing for ample far lateral lumbar decompression, including discectomy and fusion, with a low complication rate.
Keywords: Lumbar spine, minimally invasive spine surgery, muscle sparing approach, paraspinal approach, Wiltse approach
BACKGROUND
This study provides a step-by-step analysis of the Wiltse paraspinal approach, along with its pros and cons.
This is an old technique described originally in 1968. In 1988, Wiltse described additional changes to the posterolateral approach to further access foraminal lumbar disc herniations, spinal stenosis, and spondylolisthesis. This procedure additionally provided access for the removal of spinal tumors and for performing posterolateral fusions, including pedicle screws.[
MATERIAL AND METHODS
For the period between 1968 and 2016, we utilized PubMed and Lilacs and the Mesh terms “Wiltse approach,” “paraspinal approach,” “muscle sparing approach,” and “lumbar spine” to evaluate the Wiltse procedure.
We then analyzed the pros and cons of the Wiltse approach along with the following technical details: patient preparation, incision, fascial opening, dissection, bone identification, retractors, deperiostization, decompression, discectomy, instrumentation, arthrodesis, and closure.
Surgical technique
Multiple steps in the Wiltse surgical technique were assessed including preparation, positioning, incision, fascial opening, dissection, bone identification, retractors, deperiostization, decompression, discectomy, instrumentation, arthrodesis, and closure.
These procedures should be performed under neurophysiological monitoring (e.g., continuous EMG, triggering, and selective radicular stimulation), and somatosensory evoked potential monitoring. In addition, anesthesia should utilize total intravenous anesthesia (TIVA). The steps for performing this procedure are outlined in
Using blunt dissection, the medial multifidus is then separated from the lateral longissimus muscle. At the L5-S1 this exposure may be hampered by the distal insertion of the multifidus muscles [ The junction of the facet joint and the transverse processes are then identified. A Bertola tweezer is then placed for radiological confirmation of the level [ A Quadrant® (Medtronic) or Meyerding retractor then facilitates exposure, which includes removal of the periosteum from the hemilaminae to the base of the spinous process. If instrumentation is to be performed, blunt dissection of the cephalad facet is also effected to reduce the risk of adjacent segment disease (ASD) All pedicle screws are placed utilizing fluoroscopic guidance followed by application of the rods [
Figure 3
(a) The drawing depicts in A after the fascial opening the digital location of the intermuscular plane: the multifidus is medially located, the longissimus is lateral. (b) The Meyerding retractors are placed in the deep plane, the area where the joint facet and the transverse process meeting is exposed
Figure 5
The drawing shows the muscular separation plane, with the implants in place, and the bone graft in the intertransverse plane and lateral to the pars interarticularis. See the multifidus muscle, which is more lateral at the level of the sacrum, which makes location of the access plane difficult. When the retractors are removed, the muscles go back to their original position, and cover the implants and the graft
Decortication of the transverse processes, pars, and lateral facets are performed with a high-speed drill, following which bone graft is applied [
DISCUSSION
Wiltse MIS paraspinal approach is muscle-sparing and has lower infection rates vs. midline approaches.[
Street et al.[
Although Wiltse et al.[
In 2006, Olivier et al.,[
CONCLUSION
Here, we described the step-by-step Wiltse lumbar paraspinal approach to the far lateral compartment for the treatment of foraminal discs or instability warranting fusions.
Financial support and sponsorship
Nil.
Conflicts of interest
There are no conflicts of interest.
References
1. Fan S, Hu Z, Fang X, Zhao F, Huang Y, Yu H. Comparison of paraspinal muscle injury in one level lumbar posterior interbody fusion: Modified minimally invasive and traditional open approaches. Orthop Surg. 2010. 2: 194-200
2. Li H, Yang L, Chen J, Xie H, Tian W, Cao X. Magnetic resonance imaging-based anatomical study of the multifidus-longissimus cleavage planes in the lumbar spine. Am J Transl Res. 2016. 8: 109-16
3. Olivier E, Beldame J, Slimane M, Defives T, Duparc F. Comparison between one midline cutaneous incision and two lateral incisions in the lumbar paraspinal approach by Wiltse: A cadaver study. Surg Radiol Anat. 2006. 28: 494-7
4. Palmer D, Allen J, Williams P, Voss A, Jadhav V, Wu D. Multilevel Magnetic Resonance Imaging Analysis of Multifidus-Longissimus Cleavage Planes in the Lumbar Spine and Potential Clinical Applications to Wiltse's Paraspinal Approach. Spine. 2011. 36: 1263-7
5. Ran B, Yan L, Cai L. Wiltse approach versus the conventional posterior midline approach for lumbar degenerative diseases: A meta-analysis. Zhong Nan Da Xue Xue Bao Yi Xue Ban. 2015. 40: 90-101
6. Street J, Glennie A, Dea N, DiPaola C, Wang Z, Boyd M. A comparison of the Wiltse versus midline approaches in degenerative conditions of the lumbar spine. J Neurosurg Spine. 2016. 25: 332-8
7. Wiltse L, Spencer C. New uses and refinements of the paraspinal approach to the lumbar spine. Spine. 1988. 13: 696-706
8. Wiltse LL, Bateman JG, Hutchinson RH, Nelson WE. The paraspinal sacrospinalis-splitting approach to the lumbar spine. J Bone Joint Surg Am. 1968. 50: 919-26
Sergio Lutz
Posted March 6, 2018, 12:08 pm
Excelent article MIS
Congratulation in special my friend
A Falavigna